netmad0 Posted February 12, 2003 Report Share Posted February 12, 2003 I'm running OSx Ver 10.2.3 on a G4. Backup software Retrospect 5.0 Server version. Exabyte 210 scsi connection. scsi card in G4 is 2930cu The Retrospect software sees the backup unit but will not see it as a library. I can only see one tape and not the rest. In Retrospect the software does not switch from "Eject" to "loader" like it says in the book. Any suggestions? This was working on the 9.22 side. Mike Sr. Tech Hasbro, Inc. Link to comment Share on other sites More sharing options...
AmyJ Posted February 13, 2003 Report Share Posted February 13, 2003 What's the pin configuration on the Exabyte 210? 50-pin? 68-pin? While in Retrospect, go to Configure > Devices > Device Status and list Vendor, Product and Version for your drive and loader. Go to the Apple System Profiler - is the library and the drive seen here? Link to comment Share on other sites More sharing options...
netmad0 Posted February 14, 2003 Author Report Share Posted February 14, 2003 This EXABYTE 210 is a 50 pin SCSI connection. In config-device-devicescan: ID Vendor Product Version Drive SCSI-A:4 EXABYTE EXB-89008E00012F V41b EXB-8900/Mammoth DC(5.0) SCSI-A:5 EXABYTE EXB-210 6.04 SCSI In Apple system profile PCI – SLOT-D SCSI ADPT, 2930CU ADPT, 1686806-04 Vendor ID 9004 Device ID 5078 Rom# 4.0 Revision 3 BUS – IOSCSIParalleDevice SCSI Productname EXB-89008E00012F SCSI Target 4 SCSI ProductRevision V41b SCSI Lun 0 Product Identification EXB-89008E00012F SCSI Devicetype 1 Vendor Identification EXABYTE BUS – IOSCSIParalleDevice SCSI Productname EXB-210 SCSI Target 5 SCSI ProductRevision 6.04 SCSI Lun 0 Product Identification EXB-210 SCSI Devicetype 8 Vendor Identification EXABYTE Thank you very much for this help. Link to comment Share on other sites More sharing options...
netmad0 Posted March 3, 2003 Author Report Share Posted March 3, 2003 AmyC... You posted #8101 -06/05/02 to a slava the solution to this problem. I cet the drive to 1 and the loader to 4 and now I'm all set. THANK YOU VERY MUCH!!!!!!!!!!!! It pays to read the old post. Link to comment Share on other sites More sharing options...
AmyJ Posted March 3, 2003 Report Share Posted March 3, 2003 Thanks for the update~! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.