Candera Posted September 10, 2002 Report Share Posted September 10, 2002 Recently upgraded to G4 but still using Mac OS 9. Installed 4.3 and ADK and Updater. Tried more than one cable, more than one tape drive...tried running with my ATTO external drives and tried tape drive connected directly to computer. Tried intalling and uninstalling. The problem: retrospect launches fine...can see the device, but says "busy" or "no media" or "not responding." When tape drive looped off my external drives...it sees them but says "unrecongnized content." What am I missing? Link to comment Share on other sites More sharing options...
AmyJ Posted September 11, 2002 Report Share Posted September 11, 2002 While in Retrospect, go to Configure > Devices > Device Status. List Vendor, Product and Version for your drive. In reply to: Tried more than one cable, more than one tape drive...tried running with my ATTO external drives and tried tape drive connected directly to computer. You've ruled out the cable and the tape drive. The remaining factors: Terminator SCSI card Computer Try a different terminator, different card and different computer. Link to comment Share on other sites More sharing options...
Candera Posted September 11, 2002 Author Report Share Posted September 11, 2002 Sony SDX 300C version 0700 Terminator not it.... SCSI card may be it... had to update it to update to Medea drives w/ G4 so, if that's it, do I put old card in empty slot?...I'll try If its my computer...that's a little general....this tape drive has been successfully used on another computer... with the same software Link to comment Share on other sites More sharing options...
JLD Posted November 7, 2002 Report Share Posted November 7, 2002 do you use an SCSI ATTO UL3D with your G4 ? Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.