Jump to content
charlietango

Tape ejecting when not at full capacity - help

Recommended Posts

With my last few backup attempts, the tape has not been holding the full capacity of the tape size and ejects informing it is full and needs an second tape to finish the backup. Yesterday I started a 653G backup, put an LTO 4 tape in that holds 800G uncompressed. Today the backup had written 492G and had ejected with 161G remaining and needed a new tape to finish the backup. Not sure why this is happening. Thoughts anyone??

 

Thanks!

Retrospect v 6.1.126

Share this post


Link to post
Share on other sites

The estimate for tape capacity is usually WAY off.

 

Retrospect does fill the tape and doesn't request a new until it is indeed full (or you get a serious error, which you should see in the log).

 

Your source is probably too slow, or your network or your tape connection.

 

 

http://kb.retrospect.com/articles/Retrospect_Article/Tape-Capacity-FAQ/

Share this post


Link to post
Share on other sites

You may also be experiencing a problem with that particular tape member or your tape drive. LTO tape drives perform an error-check where what has been written to the tape is immediately compared with the source, and is rewritten if the comparison fails. Frequent write errors will eat up tape, and will typically show as a reduced level of performance throughput in your backups. Have you noticed any recent reduction in MB/minute performance in the logs?

Share this post


Link to post
Share on other sites

Thank you for the replies, we do a lot of Arri Alexa and DLSR footage back ups and there has been recently a significant of .DS store errors. I was told by the Retrospect tech support that the error is to be ignored so that maybe what is eating up the tape and causing it to spit out early. Also we have been in contact with HP support or our LTO 4 deck and the diagnostic we got back from them is that the machine has been cleaned "too much" and is needing replaced.

 

So that is where we are at. Thank you again for the input.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×